Measurements:
Card base (A) Rich Razzleberry
cardstock 8 ½ x 5 3/4
Piece (B) Rich Razzleberry
cardstock 5 5/8 x 5 3/8
Pieces (C1 & C2) Rich Razzleberry
cardstock 2 pieces 5 5/8 x 4 (sliding
pieces)
Piece (D) Whisper white
cardstock 5 ½ x 3 7/8
DSP (E) 5 5/8 x 3 15/16
DSP (F) 5 ½ x 3 7/8
DSP (G) 5 5/8 x 1 ¼
Cellophane band (plastic
envelope/bag that the dies come in, save them) 11 x 1 3/4
2 small pieces of ribbon
about 2 to 2 ½ inches long for the loops
Scrap piece of whisper white
for sentiment
Instructions
1. Piece (A) with the long side to the top score @ 4 1/8 flip 180 degrees
and score again @ 4 1/8
2. Piece (B) with the short side to the top score @ 4 7/8 & 4 ¾ flip 180 degrees and repeat score (cut from
edge to the first score line at an angle as shown in the picture below)
3.
4. Glue DSP (E) to (B) once the two pieces are glued take the classic label punch, centre it,
place it halfway at the edge of the cardstock and punch to create a slot as
shown in the picture below(DSP was not glued on my sample)
5.
6. Take the cellophane band and wrap
around the above piece, use tear and tape to glue both ends, overlap one end
over the other, it should slide freely.
7. Stamp image/sentiment on piece (D) before you glue it to piece (C1) take
1 piece of ribbon to form a loop use a glue dot to secure it on the right side
that will act as a pull tab.
8. Take the other piece of ribbon follow the same in step 7 and secure it
on the left side of C2, glue piece F to C2 now use the oval framelit to
make a partial die cut at both ends, place the die about 1 ½” in and this is what it will look like as shown in
the picture below
9.
10.
11. Apply tear and tape on the cellophane band to the top left and tear and
tape on the bottom right (underneath) as shown in the picture above, now take
the piece from step 7 D+C1 and adhere it to the top left and the piece from
step 8 F+C2 adhere that face up to the bottom left underneath, when you pull
the two ribbon loops this should slide freely. This completes the mechanism for
the slider.
12. Now apply glue to the two folded ends and stick it to the base of the
card.
13. Pretty up the card front with pieces F & G use the whisper white
scrap piece for your sentiment and now you have a beautiful double slider gift
card holder card.
I hope you like my card, Thank you for stopping by listed below are the products used for this project.
No comments:
Post a Comment